TV Tuner
USB TV Tuner
On
Off
Please wait to finish processing
Select your channel source
No Signal
Failed to tune to %s
Failed to tune
Tuner software has been recently updated. Please re-scan the
channels.
Enable surround sound in system sound settings to enable audio
Channel tuner setup
TV Tuner setup
USB channel tuner setup
Verify your TV is connected to a TV signal
source.\n\nIf using an over-the-air antenna, you may need to adjust its placement or
direction to receive the most channels. For best results, place it high and near a
window.
Verify the USB tuner is plugged in and connected
to a TV signal source.\n\nIf using an over-the-air antenna, you may need to adjust its
placement or direction to receive the most channels. For best results,
place it high and near a window.
- Continue
- Not now
Rerun channel setup?
This will remove the channels found from the TV
tuner and scan for new channels again.\n\nVerify your TV is connected to a TV signal
source.\n\nIf using an over-the-air antenna, you may need to adjust its placement or
direction to receive the most channels. For best results, place it high and near a
window.
This will remove the channels found from the USB
tuner and scan for new channels again.\n\nVerify the USB tuner is plugged in and connected
to a TV signal source.\n\nIf using an over-the-air antenna, you may need to adjust its
placement or direction to receive the most channels. For best results, place it high and
near a window.
- Continue
- Cancel
Select the connection type
Choose Antenna if there is an external antenna
connected to the tuner. Choose Cable if your channels come from a cable service provider.
If you are not sure, both types will be scanned, but this may take longer.
- Antenna
- Cable
- Not sure
- Development only
TV tuner setup
USB channel tuner setup
This may take several minutes
Tuner is temporarily not available or already
used by recording.
- %1$d channel found
- %1$d channels found
STOP CHANNEL SCAN
- %1$d channel found
- %1$d channels found
- Nice! %1$d channel was found during the channel scan.
If this doesn’t seem right, try adjusting the antenna position and scan again.
- Nice! %1$d channels were found during the channel scan.
If this doesn’t seem right, try adjusting the antenna position and scan again.
- Done
- Scan again
No Channels found
The scan did not find any channels. Verify
your TV is connected to a TV signal source.\n\nIf using an over-the-air antenna, adjust
its placement or direction. For best results, place it high and near a window and scan
again.
The scan did not find any channels. Verify the
USB tuner is plugged in and connected to a TV signal source.\n\nIf using an over-the-air
antenna, adjust its placement or direction. For best results, place it high and near a
window and scan again.
- Scan again
- Done
Scan for TV channels
TV Tuner setup
USB TV Tuner setup
USB TV tuner disconnected.