1 files changed, 56 insertions, 0 deletions
diff --git a/MakefileBasedBuild/Atmel/sam3x/sam3x-ek/libraries/libboard_sam3x-ek/resources/gcc/sam3x_ek_sram.gdb b/MakefileBasedBuild/Atmel/sam3x/sam3x-ek/libraries/libboard_sam3x-ek/resources/gcc/sam3x_ek_sram.gdb
new file mode 100644
index 0000000..e65eda0
--- /dev/null
+++ b/MakefileBasedBuild/Atmel/sam3x/sam3x-ek/libraries/libboard_sam3x-ek/resources/gcc/sam3x_ek_sram.gdb
@@ -0,0 +1,56 @@
+# ----------------------------------------------------------------------------
+#         ATMEL Microcontroller Software Support
+# ----------------------------------------------------------------------------
+# Copyright (c) 2008, Atmel Corporation
+#
+# All rights reserved.
+#
+# Redistribution and use in source and binary forms, with or without
+# modification, are permitted provided that the following conditions are met:
+#
+# - Redistributions of source code must retain the above copyright notice,
+# this list of conditions and the disclaimer below.
+#
+# Atmel's name may not be used to endorse or promote products derived from
+# this software without specific prior written permission.
+#
+# DISCLAIMER: THIS SOFTWARE IS PROVIDED BY ATMEL "AS IS" AND ANY EXPRESS OR
+# IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
+# MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT ARE
+# DISCLAIMED. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT,
+# INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
+# LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA,
+# OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF
+# LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
+# NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE,
+# EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+# ----------------------------------------------------------------------------
+
+ 
+#*************************************************
+#
+#  Connect to J-Link and debug application in sram on SAM3S
+#
+# Note:
+#     First, users should modify Step1 and Step2 according to their project,
+#     then do Step3.
+
+# Step1: Connect to the J-Link gdb server
+define reset
+target remote localhost:2331
+monitor reset
+
+# Step2: Load file(eg. getting-started project)
+load
+
+# Step3: Reset peripheral  (RSTC_CR)
+set *0x400e1a00 = 0xA5000004
+
+# Step4: Initializing PC and stack pointer
+# Modify pc value to even before writing pc register
+mon reg sp=(0x20000000)
+set *0x20000004 = *0x20000004 & 0xFFFFFFFE
+mon reg pc=(0x20000004)
+info reg
+
+end